Steinbach
Solar cover reels plastic for pools up to 5 m wide
- UV resistant plastic bearing blocks, plastic hand wheel
- Extendible aluminium shaft for pools up to 5 m width
- Incl. fixing kit for all solar covers
- Salzwasser geeignet
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
Rewinding unit for solar covers with fixing assembly out of plastic. For pools up to 5 m width.
- Plastic bearing blocks, plastic hand wheel
- Extendible aluminium shaft
- For pools: Stahlwandpool, Styroporpool up to 5 m width
- Suitable for salt water: yes
- Incl. fixing kit for all solar covers
- For fixed mounting
*The solar cover reels are only suitable for pools that are completely sunk into the ground.
Dimension: 323 x 41 x 46 cm
Area of application: Steel wall pool
Styrofoam pool
Suitable for salt water: yes
FAQs for Solar cover reels plastic for pools up to 5 m wide:
With the straps and plastic plates included in the scope of delivery, the solar cover is directly connected to the retractor. This allows any type of solar cover to be attached. The solar tarp can be reinforced on the fastening side, but this is not mandatory. The distance between the straps and the retractor must be long enough for the solar cover to lie completely on the water surface when unrolled.
The solar cover retractors are only suitable for pools that are fully sunken into the ground. They are installed by fixing them to the ground, which is why these retractors cannot be used for above-ground pools or pools that are only partially sunken.
In connection with this roll-up device, eyelets must be placed in the solar cover. These eyelets should always be mounted on the short side. E.g. for a solar tarp for an 8 x 4 m pool, the eyelets are mounted on the 4 m side.
FAQs from category Solar covers:
With the straps and plastic plates included in the scope of delivery, the solar cover is directly connected to the retractor. This allows any type of solar cover to be attached. The solar tarp can be reinforced on the fastening side, but this is not mandatory. The distance between the straps and the retractor must be long enough for the solar cover to lie completely on the water surface when unrolled.
The side with the air knobs must be on the surface of the water.
The production size of a solar cover corresponds to the size that is placed on the water surface of the pool. Therefore, the production dimensions of the solar cover may differ from the installation dimensions of the pool. Pay attention to the production dimensions of the solar cover. If the solar cover is too large, it can be cut to size manually.
No, due to the sun's rays and the lack of cooling by the water, the air knobs can burst.
With this solar cover reel, the solar cover is connected to the aluminum shaft using rubber bands. For this to work, the solar cover must have eyelets on one narrow side. If this is not the case, it can be retrofitted with plastic eyelets at any time. There are plastic eyelets in the well-stocked hardware store. A connection without plastic eyelets is not possible, otherwise the solar cover will tear open.
Unfortunately we do not offer custom-made products.
Solar covers utilise the power of the sun in an intelligent way. With a special bubble cover, they heat the bathing water by 3 to 5 degrees. The start and end of the bathing season can thus begin several weeks earlier or end several weeks later.