Steinbach
Stainless steel flange pipe for built-in pool ladders Ø 43 mm end bar
- Quality product
- Made from robust, high-quality V2A stainless steel
- Effortless and simple fitting of the stainless steel conductors onto the end sleeves
- No need for time-consuming cementing of the usual plastic installation sleeves
- Double pack including necessary installation material
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
The end pieces for built-in ladders are made of solid, high-quality V2A stainless steel and include all installation materials. This solution is used when the plastic installation sleeves included with the pool ladder cannot or should not be installed due to a high-quality floor covering or other reasons, such as a wooden deck. The end pieces are simply dowelled onto a solid surface, eliminating the need for time-consuming cementing. After installation, the pool ladder is simply pushed onto the end sleeves. The scope of delivery includes a double pack of flange pipes and all the necessary installation materials.
Dimension: Ø 40 x 143 mm
Suitable for ladder rail: Ø 43 mm
Scope of delivery: 2x flange tube, 2x underlay, 6x screws, 6x washers, 6x dowels
Salt water suitable: no
FAQs from category Ladder accessories:
Remove the ladder from the pool after each use, rinse it with clean tap water and dry it thoroughly with a soft, lint-free towel, paying attention to the areas in between.
Regularly check the dissolved salts in the water if an electrolysis system is used and make sure that the pH value and the disinfectant are set correctly. To avoid deposits on the underwater accessories, ensure that the water is circulated daily.
Avoid using water care products or shock chlorination in the vicinity of the ladder and ensure that no splashes or deposits form on or around the ladder.
Keep metal parts free of substances such as salts, dust and dirt and avoid contact with other metal parts, especially iron or concrete.
For salt water operation, you need a zinc plate for potential equalisation to prevent rust formation. Ensure correct installation and replace the zinc plate after each season.
The load capacity of ladders can vary depending on the model. It is between 136 kg - 150 kg. Check the product specifications of the model.
The maximum load weight must not be exceeded.
No, floor protection mats are not suitable for preparing the surface of pools. Floor protection mats made from materials such as: PE, are not stable enough. They serve as additional protection and comfort around the pool area. They can be placed under ladders, for example.